Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
- Brake system
   The general information
   System design, the description of separate knots and mechanisms
   Prorolling of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of brake system
   Replacement колодок disk brake mechanisms of forward wheels
   Replacement of boots of drum-type brake mechanisms of back wheels
   Condition check, removal and installation of disks of forward brake mechanisms
   Removal, check of a condition and installation of drums of brake mechanisms of back wheels
   Removal, major repairs and installation of supports of brake mechanisms of forward wheels
   Removal, major repairs and installation of wheel cylinders of back brake mechanisms
   Removal, major repairs and installation of the main brake cylinder (ГТЦ)
   Removal and installation of a pedal of a foot brake
   Check of serviceability of functioning, removal and installation of the vacuum amplifier of brakes
   Removal, check of a condition and installation of the control valve of the vacuum amplifier of brakes from a hose
   Adjustment of a lay brake
   Removal and installation of the lever of a lay brake
   Removal and installation of cables of a drive of a lay brake
   Check of serviceability of functioning, removal and installation of the valve-regulator of pressure in hydraulic contours of brake mechanisms of back wheels
   Removal, installation and adjustment of the gauge-switch of stoplights
   System of antiblocking of brakes (ABS) - the general information
   Removal and installation of components of systems ABS
   Removal and installation of the vacuum pump (diesel models)
   Check of a condition and major repairs of the vacuum pump (diesel models)
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Adjustment of a lay brake

For adjustment performance the steelyard is required.


 PERFORMANCE ORDER

1. Usually the tension drive a cable of a lay brake is supported in norm at the expense of action of automatic regulators of drum-type brake mechanisms of back wheels of the car. From time to time it is necessary to make additional individual adjustment for the purpose of indemnification вытягивания a cable. To make adjustment follows only at removal of brake boots, drums, cables or the lever of a drive of a lay brake.
2. Firmly having squeezed out a foot brake, make sure in испрвности conditions of the mechanism of self-regulation of back brake mechanisms.
3. Correctness of adjustment of a drive of a lay brake is checked by quantity of clicks of a ratchet of a control lever at raising of the last with effort nearby 100 ÷ 140 Н (10 ÷ 14 kg). Completely release the lever, then connect to its central part a steelyard and pull for the handle of the last with the stipulated effort - the lever should be cocked only on two clicks of the ratchet mechanism Important that the equalizer plate on the lever to which two are connected drivers a cable, remained located at right angle to a lever axis that guarantees uniformity of applying of brake effort to both back wheels.
4. For adjustment carrying out remove back section of the central console, having provided with that necessary access to the lever. If the console is not provided by a car design, release clamps and uncover the lever.
5. Release the lever, then on identical number of turns ослабьте counternuts both drivers cables on an equalizer plate. If the plate is located not at right angle to the lever, the given situation also should be eliminated in the course of adjustment at the expense of non-uniform отдавания counternuts. Some times against the stop cock the lever, then repeat check of correctness of the executed adjustment.
6. Having achieved a correct tension both drivers cables, fix adjusting nuts контрящими. Make sure that at completely released lever both back wheels rotate freely, then establish into place the central console / a decorative cover of the lever.