Skoda Felicia

1. The Gauge-switch of stoplights will screw in the top part of an arm of a pedal of a foot brake in a driver's foot well.

2. Under the panel of devices disconnect electroconducting from the top part of the gauge-switch.

3. Release a counternut, then turn out the gauge-switch and remove it from a pedal arm together with a washer.

1. Establish a counternut and a washer on the gauge-switch, then screw last in a pedal arm.
2. Connect an ohmmeter/lamp-sampler between gauge-switch plugs. Screw the gauge-switch so that the device has registered chain disconnection (infinite resistance/lamp-sampler does not burn). Smoothly having squeezed out a pedal of a foot brake, make sure of conductivity occurrence (zero resistance/lamp the sampler burns) already through 10 ч 15 mm of a course of a pedal. In case of need correct gauge-switch position, achieving demanded results.
3. At absence near at hand a measuring instrument the same adjustment can be made by visual registration of operation of stoplights (ignition is included) - take advantage of the help of the assistant.
4. Squeeze out a pedal, then extend плунжер the gauge-switch outside, having rested it against a pedal body. Release a pedal for installation плунжера.
5. Having adjusted the gauge-switch, strongly tighten a counternut and connect electroconducting. Once again make sure of serviceability of functioning of stoplights.