Skoda Felicia

Remove the panel of an internal upholstery of a door (see Has undressed Removal and installation of panels of an internal upholstery of doors).

Turn out the fixing screw, remove a washer and separate the internal handle of a door from an executive rod of the lock. Remove the handle from a door.

1. Remove the internal handle, then accurately separate from a doorframe изоляционную a film, having provided access to lock components.
2. Lower the window has flown down so that access to bolts of its fastening to a regulator window lifterа has opened. Turn out bolts, remove washers, then completely lift glass and glue its adhesive tape to a door frame.

3. Give nuts of fastening of a back rack of a regulator window lifterа to a door.

4. Take a rack aside from a door-lock.

5. Give a nut, release fixing clamps and remove from a door a cover of anticreeping protection, having provided access to замковой assemblages.

6. Separate a connecting rod from the spherical hinge of the lever замкового the cylinder.

7. Shift a fixing clamp in one of the parties, then take замковый the cylinder and remove a clamp.

1. Execute the procedures described in paragraphs with 1 on 5 subsection the Cylinder of the lock of a forward door.

2. Disconnect from the lock spherical hinges of executive rods of the external handle and замкового the cylinder.

3. On the models equipped with the uniform lock, walk on electroconducting from the door activator to a socket and disunite last. Also turn out an additional bolt of fastening to a door of an arm of internal section of the lock in which the activator is placed.

12. On all models turn out two fixing bolts and remove from a door external section of assemblage of the lock. Now the internal section can be taken from a door - try to remember adjusting positions of connecting rods of the internal button and the door handle. On the models equipped with the uniform lock the door activator acts in film complete with internal assemblage of the lock.

1. Execute the procedures described in paragraphs with 1 on 5 subsection the Cylinder of the lock of a forward door.

2. Disconnect an executive rod from the spherical hinge of the external handle.

3. Give a fixing nut, remove assembly скобу and take the handle from a door.

1. Remove the external handle of a door.
2. Turn out fixing screws, remove washers and disconnect the internal handle of a door from the executive rod. Remove the handle from a door.
3. On the models equipped with the uniform lock, walk on electroconducting from the door activator to a socket and disunite last. Also turn out a bolt of fastening of an arm of internal section of the lock to a door.

4. On all models turn out two fixing bolts and remove from a door external section замковой assemblages.

5. Disconnect an executive rod from a crank of a drive of the internal button, then liberate both rods from a door and take internal section of the lock. On the models equipped with the uniform lock the door activator acts in film complete with internal assemblage of the lock.

Installation is made upside-down. Pay attention to following moments:

a) All fixture should be tightened with demanded effort;
b) Track reliability of fastening of connecting rods on spherical hinges and correctness of their adjustment. Adjustment is made by position updating on a tip rod. Having achieved demanded result, strongly latch a rod on the hinge;
c) Before to return into place изоляционную a film and to establish panel of an internal upholstery of a door (see Has undressed Removal and installation of panels of an internal upholstery of doors) check up serviceability of functioning of the lock and both handles;
d) In summary make sure of serviceability of functioning of the lock and density of closing of a door. In case of need ослабьте fixing screws also correct position of the drummer of the lock. Having finished adjustment, tighten fixture with demanded effort.