Skoda Felicia

1. Open a back door. Separate from a door the panel of an internal upholstery and изоляционную a film for the purpose of providing of access to lock assemblage. Components замковой assemblages are presented on an illustration.

2. Disconnect an executive rod from the lock button. Disconnect electroconducting from the lock switch.

3. Turn out fixing bolts and remove assemblage of the lock from a door.

1. Open a back door. Separate from a door the panel of an internal upholstery and изоляционную a film for the purpose of providing of access to assemblage of the button of the lock.

2. Turn out fixing bolts and remove the metal arm established over the button.

3. Disconnect from the button an executive rod and take a clamp of fastening of the button.

4. Turn out fixing screws and remove assemblage of the button of the lock from a back door.

5. In case of need take a lock ring from a back part of the cylinder of the lock, remove a washer and a sealing ring, then liberate the cylinder from the facing panel - try not to drop push-button springs.

1. Open a back door. Turn out fixing screws/release clamps, then separate from a body the panel of furnish of a threshold of a door and remove it from the car.

2. Turn out fixing bolts and remove from the car a plate of the drummer of the lock. On the models equipped with a remote drive of unlocking of a door of a back, it is necessary to disconnect from the drummer приводной a cable.

Installation is made upside-down. Check up serviceability of functioning of components of assemblage of the lock, only after that start installation изоляционной films and panels of an internal upholstery of a door. In case of need correct position of the drummer.