Skoda Felicia

1. Typical components of assemblage of an external rear-view mirror are presented on an illustration.
2. Remove from the handle of adjustment of position of a mirror a rubber protective cover, then give a nut on the regulator case.

3. Having hooked, remove decorative заглушку, give the fixing screw and remove from a door the triangular decorative panel.

4. Turn out fixing screws and remove assemblage of a mirror from a door. Remove изоляционную a lining established between a support of a mirror and a door and check up its condition. The defective lining is subject to replacement.

5. Installation is made upside-down.

1. Having hooked, take decorative заглушку, then turn out the fixing screw and remove from a door the triangular decorative panel.
2. Turn out fixing screws and remove assemblage of a mirror from a door, in passing having disunited an electroconducting socket. Remove изоляционную a lining. The damaged lining is subject to replacement.
3. Installation is made upside-down.

1. Incline mirror glass against the stop upwards, then pass a plastic or wooden wedge between the basis of glass and a casing of a framework and, accurately having hooked, separate glass from drive the electromotor/regulator.
2. Remove glass from a framework and disconnect electroconducting from a heating element.
3. At installation do not forget to connect electroconducting and track reliability защелкивания glasses on the electromotor/regulator (put effort only to the central part of glass for the purpose of minimisation of casual damage of the last). Having made sure of reliability of fixing of glass, adjust mirrors, having resulted it into position.