Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
- Engine repair
   + Repair without extraction from the car of the petrol engine of 1.3 l
   - Repair without extraction from the car of the petrol engine of 1.6 l
      The description of the basic knots and mechanisms
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ) the end of a step of compression
      Check компрессионного pressure - an order of carrying out and interpretation of results
      Removal and installation of a belt of drive ГРМ and its covers
      Removal, check of a condition and installation of cogwheels and натяжителя a belt of drive ГРМ
      Removal, installation and adjustment of effort of a tension of a belt of a drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of a camshaft
      Replacement of epiploons of a cranked shaft
      Removal and installation of a head of cylinders in gathering with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Removal, check of a condition and flywheel installation
      Check of a condition and replacement of support of the power unit
      Removal and pallet installation картера the engine
      Removal and installation of the oil pump and маслозаборника
   + Repair without extraction from the car of the diesel engine
   + Dismantle of the power unit and engine major repairs
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Check of a condition and replacement of support of the power unit

The detailed information on placing and the device of support of the power unit is resulted in Section 1 of Part D of the present Chapter.

CHECK

 PERFORMANCE ORDER

1. Поддомкратьте redock of the car also establish it on props.
2. Check up rubber pillows of support on presence of cracks, hardening signs, отслоений rubbers from a metal basis and other mechanical damages. In case of this sort of revealing of defects the faulty support is subject to replacement.
3. With the help динамометрического a key check up correctness of effort of a tightening of carving connections of support.
4. Using as the lever the big screw-driver or mount, estimate degree of deterioration of support (whenever possible take advantage of the help of the assistant, having asked it to shake the power unit here and there). In case of revealing excessive люфта it is necessary to replace the worn out support, preliminary having checked up reliability of a tightening of its fixture.

REPLACEMENT

The right support

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Will hang out the engine with the help лебедки, or having propped up its jack (between a head of a jack and the pallet картера for loading distribution it is necessary to lay wooden брусок).

3. Turn out the top coupling bolt иотсоедините a support...

... Trying to remember adjusting position of removed components, take from assemblage a rubber pillow.

4. The remained bolts now can be turned out, and the support is removed from a mudguard of an arch of a wheel.
5. In case of need the bottom part of a support can be separated from the block of the engine after preliminary removal of covers of a belt of drive ГРМ (see Has undressed Removal and installation of a belt of drive ГРМ and its covers).
6. Installation is made upside-down. Do not forget to replace fixing bolts and slightly to grease them before installation by lubricating oil. All fixture tighten with demanded effort.


The left support


The Section Check of a condition and replacement of rubber pillows of support of a suspension bracket of the power unit see.

Back support


The Section Check of a condition and replacement of rubber pillows of support of a suspension bracket of the power unit see.