Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
- Engine repair
+ Repair without extraction from the car of the petrol engine of 1.3 l
+ Repair without extraction from the car of the petrol engine of 1.6 l
- Repair without extraction from the car of the diesel engine
The description of the basic knots and mechanisms
Reduction of the piston of the first cylinder in position of the top dead point (ВМТ) the end of a step of compression
Check of tightness of chambers of combustion
Removal and installation of a belt of drive ГРМ and its covers
Removal and installation натяжителя and cogwheels of a belt of drive ГРМ
Removal, installation and adjustment of a tension of a belt of a drive of auxiliary units
Removal and installation of a cover of a head of cylinders
Replacement of an epiploon of a camshaft
Replacement of an epiploon of an intermediate shaft
Replacement of epiploons of a cranked shaft
Removal and installation of a head of cylinders in gathering with the inlet pipeline and a final collector
Check of serviceability of functioning of hydraulic pushers
Flywheel - removal, check and installation
Support of the power unit - check and replacement
The pallet - removal, check and installation
Removal and installation of the oil pump and assemblage маслозаборника
+ Dismantle of the power unit and engine major repairs
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment
|
Flywheel - removal, check and installation
The general information
The flywheel fastens to a flange of a cranked shaft six bolts М10х1. Asymmetrical placing болтовых apertures excludes possibility of wrong installation of assemblage for the purpose of balancing preservation. At installation bolts of fastening of a flywheel are subject to replacement without fail. Before вворачиванием the carving part of new bolts is greased with fixing hermetic of type Loctite 547 or Loctite 270. Before installation of its new gear wreath it is necessary to warm up in the electric furnace to temperature 400°С. The flywheel is calculated on installation of assemblage of coupling in diameter of 200 mm. On a flywheel label ВМТ of the piston of the first cylinder which at performance of corresponding repair work should be combined with the reciprocal index on a coupling dome is provided.
Removal, check and installation
See Has undressed Removal, check of a condition and flywheel installation. |
|