Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
- Engine repair
   + Repair without extraction from the car of the petrol engine of 1.3 l
   + Repair without extraction from the car of the petrol engine of 1.6 l
   - Repair without extraction from the car of the diesel engine
      The description of the basic knots and mechanisms
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ) the end of a step of compression
      Check of tightness of chambers of combustion
      Removal and installation of a belt of drive ГРМ and its covers
      Removal and installation натяжителя and cogwheels of a belt of drive ГРМ
      Removal, installation and adjustment of a tension of a belt of a drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of a camshaft
      Replacement of an epiploon of an intermediate shaft
      Replacement of epiploons of a cranked shaft
      Removal and installation of a head of cylinders in gathering with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Flywheel - removal, check and installation
      Support of the power unit - check and replacement
      The pallet - removal, check and installation
      Removal and installation of the oil pump and assemblage маслозаборника
   + Dismantle of the power unit and engine major repairs
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment



Reduction of the piston of the first cylinder in position of the top dead point (ВМТ) the end of a step of compression

 PERFORMANCE ORDER

1. Uncover heads of cylinders, a belt of a drive of auxiliary units and external covers газораспределительного a belt (Sections Removal, installation and adjustment of a tension of a belt of a drive of auxiliary units, Removal and installation натяжителя and cogwheels of a belt of drive ГРМ, Check of tightness of chambers of combustion accordingly see).

2. Remove заглушку an observation port from a coupling dome...

... Also turn a cranked shaft a key clockwise, achieving position when the label on a flywheel will appear in the middle of an observation port aperture.

3. For engine fixing in position ВМТ it is necessary to block a camshaft (not its cogwheel) and cogwheel ТНВД in adjusting position by means of special tools. Despite potential possibility of independent manufacturing of the equivalent adaptations, necessary accuracy of measurements demands to prefer firm блокираторам. Composers of the present Management recommend arrived now in sale блокираторы firms Sykes Pickavant).

4. Enter working edge блокиратора into gearing with a groove a camshaft end face.

5. Without taking блокиратор, slightly turn a cranked shaft clockwise (as did it earlier) so that блокиратор has rested against a surface of a head of cylinders. From the opposite end блокиратора with the help probeа лезвийного type measure a backlash an end face of the adaptation and a head.

6. Slightly turn a camshaft in the opposite direction and take probe. Now it is necessary to level блокиратор, путам introductions from its both parties of two edges, the thickness of each of which should be equal to half of backlash measured at the previous stage. On termination of a centering of a camshaft timing it is possible to consider installation of phases finished.

7. Having passed a special blocking pin in an adjusting aperture of cogwheel ТНВД and in a nave groove, fix the pump in adjusting position.

8. Now the engine will appear resulted in position ВМТ of the end of a step of compression of the piston of the first cylinder.