Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
- Engine repair
   + Repair without extraction from the car of the petrol engine of 1.3 l
   + Repair without extraction from the car of the petrol engine of 1.6 l
   - Repair without extraction from the car of the diesel engine
      The description of the basic knots and mechanisms
      Reduction of the piston of the first cylinder in position of the top dead point (ВМТ) the end of a step of compression
      Check of tightness of chambers of combustion
      Removal and installation of a belt of drive ГРМ and its covers
      Removal and installation натяжителя and cogwheels of a belt of drive ГРМ
      Removal, installation and adjustment of a tension of a belt of a drive of auxiliary units
      Removal and installation of a cover of a head of cylinders
      Replacement of an epiploon of a camshaft
      Replacement of an epiploon of an intermediate shaft
      Replacement of epiploons of a cranked shaft
      Removal and installation of a head of cylinders in gathering with the inlet pipeline and a final collector
      Check of serviceability of functioning of hydraulic pushers
      Flywheel - removal, check and installation
      Support of the power unit - check and replacement
      The pallet - removal, check and installation
      Removal and installation of the oil pump and assemblage маслозаборника
   + Dismantle of the power unit and engine major repairs
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Removal and installation of a cover of a head of cylinders

REMOVAL

 PERFORMANCE ORDER

1. Disconnect from a cover of a head of cylinders a tube of system of ventilation картера. If the sealing plug through passage is damaged, pick up the replaceable approaching on a standard size.
2. Having hooked, take заглушки, give three fixing nuts, remove washers and уплотнители. Try to remember adjusting position of removed components. The damaged washers are subject to replacement.
3. In case of need обстучав on perimetre a hammer with soft brisk, uncover a head.
4. Remove a lining, attentively study its condition, in case of revealing of signs of ageing of a material or mechanical damages pick up the replaceable.
5. Carefully smooth out interfaced surfaces of a cover and a head of cylinders, completely having removed from them traces of oil and a material of an old lining.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. Pay attention to following moments:

a) Track correctness of placing of a lining on a head - all provided apertures should appear are combined with available in an interfaced surface;
b) Make sure of presence on the regular places on three hairpins of a cover of sealing cones;
c) Try not to displace a lining in the course of cover lowering on a head;
d) Establish in a former order of a washer and уплотнители, then screw fixing nuts and tighten them with demanded effort. Establish заглушки;
e) Restore initial connection of a ventilating tube, in case of need having replaced the sealing plug through passage.