Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
- Transmission
   The general information
   The description of knots and mechanisms
   Removal and installation of draughts of a drive of a gear change
   Replacement of epiploons
   Check of serviceability of functioning, removal and installation of the gauge-vyklju-chatelja of fires of a backing
   Removal and installation of the mechanism of a drive of a speedometer
   Removal and transmission installation
   Major repairs РКПП, dismantling and assemblage of knots and components
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Removal and installation of draughts of a drive of a gear change

REMOVAL

 PERFORMANCE ORDER

At assemblage the new cylindrical pin of fastening of a rod of a choice of transfers is required.

1. Park the car on an equal horizontal platform, whenever possible with a firm covering. Firmly cock a lay brake, then поддомкратьте redock of the car and establish it on props.

2. With трансмиссионного the end of a rod of a choice of transfers remove a fixing collar, having provided with that access to a cylindrical pin of fastening of a rod on an axis of plugs of switching РКПП.

The collar of a standard complete set at assemblage will replace more correctly screw or worm. With the help выколотки beat out a pin.

- At assemblage it is subject to replacement without fail.

3. Give a nut of an axial bolt of fastening of a rod of a choice to the basis of control lever rkpp / to the BASIC plate, then disconnect the forward end of an external rod from an axis of plugs of switching in a transmission and remove a rod from the car. Take the old axial plug () from the switching lever.

4. Turn away the handle of control lever РКПП, liberate a protective cover from the central console and remove it from the lever.
5. Under the car turn out bolts and remove скобу a back support of a bar of the mechanism of switching to a body. Remove a rubber pillow of a support - try not to drop remote washers.

6. Turn out a unique bolt of fastening of a bar of the mechanism of switching to transmission, remove washers and take a rubber pillow of a support. Take assemblage of a bar of the mechanism of switching with control lever РКПП from under the car.

7. In case of need the bar can be disconnected from the lever after removal of sealing covers and a lock ring, - try to remember adjusting position of all removed components.
8. Carefully wipe all removed components and check up them on presence of signs of deterioration or mechanical damages. Defective details replace - the majority of them is delivered on the automobile market in an individual order.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. The special attention should be turned for following moments:

a) do not forget to grease all basic and rotary knots of a drive of a gear change with universal greasing;

b) Before вворачиванием carefully clear a carving of bolts of fastening of a bar of old hermetic, then grease their fresh, type Loctite 270 or Three bond 1305. Track that the fixture has been tightened with demanded effort;
c) Carefully clean a carving of a bolt of fastening of a rod of a choice of transfers to the lever. Before вворачиванием slightly grease with its fresh fixing hermetic (the point b see). Track, that the bolt nut has been tightened with demanded effort;
d) Fastening of a rod of a choice of transfers to an axis of plugs of switching should be carried out by means of a new cylindrical pin. Fix the inserted pin a collar of screw or worm type.