Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   + System of the central injection (SPFI) the petrol engine
   + System of the distributed injection (MPFI) the petrol engine
   - The power supply system of the diesel engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner and components of an inlet path
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Removal and installation ТНВД
      Check and adjustment of the maximum turns of the engine and idling turns
      Check of installation of turns of fast idling
      Check and updating of installation of phases of injection ТНВД
      Removal and installation of atomizers
      Removal and installation electromagnetic запорного the valve
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment
Обучение заточке парикмахерских инструментов еще на сайте.


Removal, installation and adjustment of a cable of an accelerator

REMOVAL

 PERFORMANCE ORDER

1. Remove the sections of furnish of the panel of devices established under a steering column.
2. Slightly squeeze out a pedal of an accelerator and disconnect a tip drive a cable from the plug on the top end of a pedal.
3. Having liberated the plug through passage, pass a cable through an aperture in a partition of an impellent compartment

4. In an impellent compartment liberate a tip of a cable from executive lever TNVD. Remove the rubber plug in which the tip is planted.

5. Remove a lock cap of a cover of a cable and push last through the rubber plug through passage. Liberate the plug from a basic arm of a cable.

6. Liberate a cable from directing intermediate clamps and take it from an impellent compartment.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down.

ADJUSTMENT

 PERFORMANCE ORDER

On ТНВД fix a cable cover in a basic arm, having filled a metal lock ring in one of specially provided flutes so that at full squeezing of a pedal of gas the lever slightly nestled on the emphasis.