Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   - System of the central injection (SPFI) the petrol engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner
      The vacuum switch of a control mean in temperature of soaked up air
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of components of system Bosch Mono-Motronic
      Removal and installation of assemblage of a gasoline pump and the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Dump of residual pressure in the power supply system
      Removal and installation of the inlet pipeline
      Check of functioning and adjustment of system of injection
      Neetilirovannoe fuel - the general information and use rules
   + System of the distributed injection (MPFI) the petrol engine
   + The power supply system of the diesel engine
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


The vacuum switch of a control mean in temperature of soaked up air

REMOVAL

 PERFORMANCE ORDER

1. Remove an air cleaner casing (see Has undressed Removal and installation of assemblage of an air cleaner).
2. Disconnect from the vacuum switch the remained vacuum tube about (going to a vacuum capsule of a casing of the valve-switch). Try a route of a lining of a tube.
3. Having hooked a small screw-driver with a flat sting, remove a basic plate from the bottom party of the vacuum switch. The plate can appear planted densely enough, therefore operate extremely cautiously, trying not to damage штуцерных branch pipes.
4. Remove the vacuum switch from an air cleaner casing. Clean a lining.

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down. The damaged lining at assemblage should be replaced. Track density of landing of a basic plate on штуцерных branch pipes.