Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   - System of the central injection (SPFI) the petrol engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner
      The vacuum switch of a control mean in temperature of soaked up air
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of components of system Bosch Mono-Motronic
      Removal and installation of assemblage of a gasoline pump and the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Dump of residual pressure in the power supply system
      Removal and installation of the inlet pipeline
      Check of functioning and adjustment of system of injection
      Neetilirovannoe fuel - the general information and use rules
   + System of the distributed injection (MPFI) the petrol engine
   + The power supply system of the diesel engine
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment
apteka-viagri.com


Removal, installation and adjustment of a cable of an accelerator

REMOVAL

 PERFORMANCE ORDER

1. Remove an air cleaner casing (see Has undressed Removal and installation of assemblage of an air cleaner).

2. On the throttle case disconnect the core of a cable from a plate of a spindle throttle заслонки - the core should be delayed, and then to disconnect a tip.

3. Remove a cap from the external end of a cover of a cable, then liberate from a basic arm the rubber plug through passage which can be thrown off from a cover later.

4. In car salon liberate a connecting nipple of a cable from a clamp on the top end of a pedal of an accelerator.
5. Liberate a cable from intermediate directing clamps and pass through it through a partition of an impellent compartment (try not to damage the rubber plug through passage).

INSTALLATION

 PERFORMANCE ORDER

Installation is made upside-down.

ADJUSTMENT

 PERFORMANCE ORDER

Fix a cable cover in a basic arm on the throttle case for what latch a metal lock ring in one of cover grooves so that at an emphasis of the lever of a drive throttle заслонки in a stopper of position of idling all weak point of a cable appeared chosen.