Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system
   + The power supply system of the carburettor engine of 1.3 l
   + System of the central injection (SPFI) the petrol engine
   - System of the distributed injection (MPFI) the petrol engine
      The general information and safety measures
      Removal and installation of assemblage of an air cleaner
      Control mean in temperature of soaked up air - the general information
      Removal, installation and adjustment of a cable of an accelerator
      Removal and installation of components of system of injection Simos 2P
      Removal and installation of components of system of injection Magneti-Marelli 1AV
      Removal and installation of assemblage of the fuel pump and the gauge of measurement of the expense of fuel
      Removal and installation of a fuel tank
      Dump of residual pressure in the power supply system
      Removal and installation of the inlet pipeline
      Check of serviceability of functioning and adjustment of system of injection
      Neetilirovannoe fuel - the general information and use rules
   + The power supply system of the diesel engine
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment


Removal, installation and adjustment of a cable of an accelerator

REMOVAL

 PERFORMANCE ORDER

1. Uncover, established on the throttle case (see Has undressed Removal and installation of assemblage of an air cleaner).

2. On the throttle case disconnect the core of a cable from a plate of a spindle throttle заслонки - the core should be delayed, and then to disconnect a cable tip.

3. Remove a lock cap from the external end of a cover of a cable.

4. Stretch a cable through the rubber plug through passage, having liberated it from a basic arm., then liberate from a basic arm the rubber plug through passage which then can be thrown off from a cover.

5. In car salon disconnect an internal tip of a cable from the plug on the top end of a pedal of gas.

6. Liberate a cable from intermediate directing clamps and pass through it through a partition of an impellent compartment (try not to damage the rubber plug through passage).

INSTALLATION

 PERFORMANCE ORDER

1. Installation is made upside-down.

2. Fix a cable cover in a basic arm on the throttle case for what latch a metal lock ring in one of cover grooves so that at completely squeezed out pedal throttle заслонка slightly nestled on a trailer emphasis.