|
1. Eventually in the fuel filter the moisture which should be merged periodically collects containing in дизтопливе.
2. The fuel filter is established in the right back corner of an impellent compartment.
|
|
3. Remove located in the top part of the fuel filter a R-shaped clamp and take the management valve, having left connected fuel hoses. |
4. Give the screw of a fixing arm and slightly raise the filter.
5. Establish under filter assemblage drain capacity and prepare rags for gathering of a spilt liquid.
6. Open the drain gate in the basis of the filter and lower assemblage contents in the prepared capacity. Do not close the gate until from the filter 3 fuels mixed with water will not flow out about 100 sm.
7. Establish into place the management valve, having fixed its R-shaped clamp. Close the drain gate and wipe its pure rags.
8. Take drain capacity and rags, fill the filter in an arm and strongly tighten the fixing screw.
9. Start the engine and allow to it to work on single turns, checking the filter on presence of signs of leaks of fuel.
10. Some times lift turns of the engine to 2000 in a minute, at once again dumping them to the single. Make sure of absence of air bubbles a fuel stream in connected to ТНВД a translucent hose. |