|
|
Skoda FeliciaSince 1994 of releaseRepair and car operation |
|
|
Shkoda Felitsija + Cars of mark Skoda Felicia + The maintenance instruction + Routine maintenance + Engine repair - Systems of cooling, heating The general information and safety measures Detachment and replacement of hoses of system of cooling Removal, check of a condition and radiator installation Removal, check of serviceability of functioning and thermostat installation Check of serviceability of functioning, removal, installation, dismantling and assemblage of the fan of system of cooling Check of serviceability of functioning, removal and installation of electric switches and gauges of system of cooling Removal, installation, dismantling and assemblage of the water pump System of heating/ventilation of salon - the general information Removal and installation of components of system of heating/ventilation of salon Air central air - the general information and safety measures Removal and installation of components of a central air of air + The power supply system + Engine electric equipment + Coupling + Transmission + Power shafts + Brake system + Suspension bracket and steering + Body and salon furnish + Onboard electric equipment |
Detachment and replacement of hoses of system of cooling
If during performance of the checks listed in corresponding Section of the Head Routine maintenance, defects of hoses of system of cooling are revealed, they should be replaced. Empty cooling system. If the cooling liquid filled in a path is enough fresh, it is subject to a reuse and should merge in pure container. Try to remember a route of a lining of a hose subject to replacement. For a hose detachment ослабьте collars of its fastening on unions/branch pipes of corresponding components. Shift collars on a hose, completely having released посаженые on unions sites of the last. Cautiously remove a hose from the unions/branch pipes. For fastening of hoses collars of two types are used: standard, and also spring, for отпускания which it is necessary to compress flat-nose pliers the free ends. Remember that inlet and final branch pipes of a radiator are fragile enough elements - do not make excessive efforts at снимании from them hoses. For simplification of removal повращайте a hose on the union. As a last resort, strongly "become attached" hose can be cut off from a branch pipe a knife - despite connected with in such a way certain material inputs, nevertheless will replace more cheaply a hose, than to get a new radiator (nevertheless, preliminary make sure available near at hand a replaceable hose). At installation of a new hose at first put on it fixing collars, only after that pull a hose on unions/branch pipes of corresponding components охладительного a path. Some hoses and their unions are equipped by landing labels - take care of their correct combination. For simplification of landing of rigid hoses on unions it is necessary to moisten slightly the ends of the last with a soap solution, or preliminary to warm up in warm water the hose ends - do not use as greasing any oils. Pull a hose the ends on unions and check up correctness of its lining in an impellent compartment. Displace collars by the hose ends, having got them for развальцовку unions/branch pipes. Tighten coupling screws. Fill cooling system (Routine maintenance see the Head). Start the engine, then attentively check up system on presence of signs of leaks of a cooling liquid. |
|