Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
- Transmission
The general information
The description of knots and mechanisms
Removal and installation of draughts of a drive of a gear change
Replacement of epiploons
Check of serviceability of functioning, removal and installation of the gauge-vyklju-chatelja of fires of a backing
Removal and installation of the mechanism of a drive of a speedometer
Removal and transmission installation
Major repairs РКПП, dismantling and assemblage of knots and components
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment
|
Check of serviceability of functioning, removal and installation of the gauge-switch of fires of a backing
CHECK
|
|
|
1. Management of functioning of fires of a backing is carried out by means of screwed from above in the basis картера gauge-switch transmissions плунжерного type. In case of infringement of functioning of fires first of all check up a condition of a corresponding safety lock.
2. For gauge-switch check disconnect from it electroconducting (one or two sockets). By means of an ohmmeter or a lamp-sampler make sure available conductivity between gauge-switch plugs at the chosen reverse gear. In case of negative result of check and absence of visible defects of electroconducting of a corresponding contour it is necessary to replace actually the gauge-switch. |
|
REMOVAL
|
|
|
|
At assemblage the new sealing washer is required. |
1. Firmly cock a lay brake, then поддомкратьте redock of the car and establish it on props.
|
|
2. Disconnect electroconducting from the gauge-switch of fires of a backing - one or two sockets. |
3. Prepare for gathering of spilt oil. Find a suitable stopper for закупоривания apertures under gauge-switch installation.
4. Carefully wipe a surface картера round the gauge-switch. Turn out the gauge and remove it together with a sealing washer. Закупорьте an aperture the prepared stopper. |
|
INSTALLATION
|
|
|
1. Replace a sealing washer, then take заглушку and screw the gauge-switch on the regular place in картер transmissions. Tighten the gauge with demanded effort.
2. Restore initial connection of electroconducting, having tracked reliability of fastening of a plait in all intermediate clamps.
3. Lower the car on the earth and check up level трансмиссионного oils in a transmission. In case of need make corresponding updating. Check up serviceability of operation of fires of a backing. |
|
|
|