Skoda Felicia

Since 1994 of release

Repair and car operation



Shkoda Felitsija
+ Cars of mark Skoda Felicia
+ The maintenance instruction
+ Routine maintenance
- Engine repair
   + Repair without extraction from the car of the petrol engine of 1.3 l
   + Repair without extraction from the car of the petrol engine of 1.6 l
   + Repair without extraction from the car of the diesel engine
   - Dismantle of the power unit and engine major repairs
      Removal from the car of the power unit - preparation and safety measures, the general data on a suspension bracket of the power unit
      Removal, partition and installation of the power unit
      Engine major repairs - preliminary data
      Dismantling, clearing, check of a condition and assemblage of a head of cylinders
      Removal, check of a condition and installation of a camshaft and pushers of valves (the engine 1.3)
      Removal and installation of an intermediate shaft (the diesel engine)
      Removal, check of a condition and installation of shatunno-piston assemblages
      Removal and check of a condition of a cranked shaft
      Cleaning and check of a condition of the block of cylinders/kartera of the engine
      Check of a condition and selection of loose leaves radical and шатунных bearings of a cranked shaft
      Assembly order of the engine after major repairs performance
      Installation of a cranked shaft and check of working backlashes of radical bearings
      Installation of piston rings
      Installation of shatunno-piston assemblages on the engine and check of working backlashes шатунных bearings
      Initial start of the engine after end of its major repairs
+ Systems of cooling, heating
+ The power supply system
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body and salon furnish
+ Onboard electric equipment



Removal and installation of an intermediate shaft (the diesel engine)

REMOVAL

 PERFORMANCE ORDER

1. Remove a belt of drive ГРМ and a cogwheel of an intermediate shaft.

2. Having measured size of a longitudinal course of a shaft, estimate its axial люфт. The tsiferblatnyj measuring instrument should be fixed on the block of cylinders to coaxially shaft, having pressed плунжер to an end face of a pin of the last. In the rest procedure is identical to that, described for a camshaft. If the result of measurement exceeds the limiting value stipulated in Specifications for a camshaft, make replacement of an intermediate shaft.

3. Turn out fixing bolts and remove a flange of an intermediate shaft.

4. Remove a sealing ring and take an epiploon.

5. Take an intermediate shaft from the block of cylinders and check up a condition приводной gear wheels at its end face. In case of revealing of defects or signs of excessive deterioration of teeths it is necessary to replace a shaft.
6. If leaks through a shaft epiploon took place, check up a condition of a surface of a pin of a shaft.

INSTALLATION

 PERFORMANCE ORDER

1. Grease necks and приводную a gear wheel with oil, then accurately fill a shaft in the block of cylinders.
2. Запрессуйте a new epiploon in a nest of a flange of a shaft. In a flute from the interior of a flange enclose a new sealing ring.
3. Grease internal sponges of an epiploon with pure impellent oil of m plant a flange on a shaft pin. Make sure of correctness of landing of a sealing ring, then screw fixing bolts and tighten them with demanded effort. Check up freedom of rotation of an intermediate shaft.
4. Establish into place a cogwheel of an intermediate shaft and tighten a bolt of its fastening with demanded effort.